Flow-passage design determines efficiency, while materials and heat treatment determine strength and service life. Machining accuracy and dynamic balancing grade directly affect vibration, noise and oil-seal life. Many recurring leakage and high-speed vibration issues originate here rather than in catalogue parameters.

1. Coaxiality accuracy: inferior products >0.05 mm; high-end models ≤0.015 mm. 

Coaxiality reflects the alignment of input and output shaft axes. Inferior products typically exceed 0.05 mm, producing pronounced eccentric motion at high speed, resulting in housing vibration, increased bearing loads and uneven oil-seal lip wear. Some high-end models, such as Guangdong Zhongxing high-end versions, control coaxiality to ≤0.015 mm, substantially reducing eccentricity, improving high-speed stability, equalizing seal loading and slowing wear. Although the numerical difference is small, it is multiplied during continuous operation at several hundred to over a thousand rpm.

2. Dynamic balancing grade: generic G16, conventional G6.3, high-end G1–G2.5. 

Dynamic balancing grade indicates rotor mass-distribution accuracy; a lower grade number denotes higher balancing precision. Generic products are typically G16, with large residual unbalance; the higher the speed, the greater the centrifugal force and the more pronounced the vibration and noise. Conventional products are G6.3, suitable for general applications. High-end models can achieve G1–G2.5, approaching precision-rotor levels. Higher balancing accuracy reduces vibration, slows seal wear and lowers leakage probability. This explains why some couplings with otherwise acceptable seals leak prematurely: the seals are worn by vibration rather than failing intrinsically.

3. Internal-cavity finishing: blade burrs intensify turbulence and useless heat generation. 

When castings are not ground and blade burrs remain, local oil-flow disturbance intensifies, creating additional turbulence, increasing useless heat generation and power loss, and manifesting as higher temperature rise and lower efficiency. Quality products finish and polish internal cavities and blades to ensure smooth flow-passage surfaces, orderly oil circulation and reduced unnecessary energy loss. This complements flow-passage design; poor machining can offset design advantages.

Conclusion: Machining accuracy and dynamic balancing grade are ultimately reflected in three phenomena: high-speed vibration, premature seal wear and leakage, and excessive temperature rise under the same load. During procurement, verify three data points: coaxiality control value, dynamic balancing grade, and whether internal cavities are finished and polished. Coaxiality ≤0.015 mm, dynamic balancing accuracy G2.5 or better, and finished internal cavities together ensure vibration, noise and seal-life performance.